Four way traffic control in Rockwell Software Studio 5000

-

 Four way traffic control in Rockwell Software Studio 5000 


Here a four-junction traffic signal is considered that has four set of signals each with a red, amber and green LEDs.

Latch and Unlatch logic are used to design 4-way traffic control.

Logix 5000 routine








HMI in FactoryTalk View Studio










Comments

Post a Comment

Popular posts from this blog

Simple Latch Circuit in Siemens TIA Portal V16

-
Image
  Simple Latch Circuit in Siemens TIA Portal V16 Step 1: Configuring the PLC Hardware in TIA Portal Open your project in TIA Portal and access the  Project View . Your configured PLC appears here. To add more hardware slots/modules, click the slot addition option in the project view and select your module. It will appear attached to your PLC overview. Enlarge the PLC view to 400% for better visibility of inputs, outputs, and the LAN interface.   Step 2: Setting IP Addresses for Network Communication Double-click the LAN interface in your PLC project to see its IP address. Check your computer’s Ethernet LAN card IP address via network settings. Example: PLC IP = 192.168.0.1; PC LAN card IP = 192.168.0.2 Ensure your PC IP address is either greater or lesser than the PLC’s to maintain proper networking basics. This setup enables communication between your PLC and PC over Eth...
Read more

SOC Estimation and modelling of Electric Vehicle EV in MATLAB

-
Image
By: Nachiketh.V. Boin  YouTube Video:  SOC Estimation of Electric Vehicle (EV) in Matlab-Simulink #Simulink_Student_Challenge_2022 - YouTube For Simulink Model File:    nachikethboin/SOC-Estimation-of-Electric-Vehicle-EV-in-MATLAB (github.com) Aim:  Modeling and Simulation of Electric Vehicle (EV) using Matlab Objectives:    1. To make a simple, low run-time model of an electric vehicle using individual component models.  2. To check performance parameters: Speed, SOC, current, etc. with various drive cycles.  3. To play with: motor power, vehicle body (rolling resistance, air drag, weight) inputs.  4. To know MATLAB models and their configurations to match with an actual vehicle. Software used:    MATLAB-SIMULINK   MATLAB Packages  Used:   Simscape package, also need the driveline package, the powertrain block set package and electrical package. All for Simscape.  Illustration of general EV Configu...
Read more

Pick and Place Robot in Siemens Tecnomatix Plant Simulation

-
Image
Pick and Place Robot in Siemens Tecnomatix Plant Simulation Project Files ( GitHub ) :  nachikethboin/Pick-and-Place-Robot-in-Siemens-Tecnomatix-Plant-Simulation     1. Building a Simple Pick and Place Robot Model Insert Basic Elements: Place a  Source  and a  Conveyor . Select both (plus connector), copy, and paste to duplicate (now you have two sources and conveyors). Add a  Pick and Place Robot , a  Station , another  Conveyor , and a  Drain . Connect the conveyors and station to the pick and place robot so the robot can transfer parts between them. Optimize Robot Workflow: Reduce the processing time of the station so the robot doesn’t have to wait and always has a free spot to place the part. Run the simulation to see the robot pick up parts from the conveyor and place them at the station. 2. Understanding the ...
Read more